Friends,
While programming PIC 16F676 with a programmer (Pic Flash - India made) an error message "Configuration Bit Programming Failed" shows. But if the device is erased and re-programmed, programming successful. In case of a brand new device, the result is same. What I do is first erase the new device (though the device is blank) then program it to have the result successful. The configuration bit is as below. Your comment is solicited.
swapan
__CONFIG _CP_OFF & _CPD_OFF & _BODEN_OFF & _MCLRE_OFF & _WDT_OFF & _PWRTE_ON & _INTRC_OSC_NOCLKOUT
While programming PIC 16F676 with a programmer (Pic Flash - India made) an error message "Configuration Bit Programming Failed" shows. But if the device is erased and re-programmed, programming successful. In case of a brand new device, the result is same. What I do is first erase the new device (though the device is blank) then program it to have the result successful. The configuration bit is as below. Your comment is solicited.
swapan
__CONFIG _CP_OFF & _CPD_OFF & _BODEN_OFF & _MCLRE_OFF & _WDT_OFF & _PWRTE_ON & _INTRC_OSC_NOCLKOUT