Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Component Designator's (PCB Design)

Status
Not open for further replies.
Hey everyone.

I just wanted to find out if there's a standard, or to get people's thoughts on component designators when it comes to PCB design.

I understand that values shouldn'y be printed on a silk screen just in case component values need to change.

Here's what I have;
B for siren, buzzer, speaker
C for Caps
D for Diodes, LED's
H for heatsink
IC for Intergated circuits, voltage regulators, microcontrollers, logic IC's and mosfet drivers etc..
J for connector, Jumper and Header pins
L for inductor
R for Resistors, resistor networks, and Variable Resistors
S for switch, push button,
T for Transistors, MOSFETs, JFET's
TP for test point
X for Cystal

So i'm only guessing, please correct/suggest any mistakes/changes
I will update the list as I get feedback.
 
The only thing I see incorrect in the original list is the transistor symbol is Q, not T, and I see U now instead of IC for a chip. That Wiki article is pretty complete.
 
The only thing I see incorrect in the original list is the transistor symbol is Q, not T, and I see U now instead of IC for a chip.

Eagle uses T for some FET parts. I don't mind T or Q. I do prefer IC though.

The most important thing is to be consistent. Especially on one board (or it becomes a mess) but also across multiple boards you design.
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top