RichardKhoo
New Member
hi guys...
i'm in a rush for this project.. and i've no idea how to start with it
i have to finish it within 1 and half months from now.
ok.. let me explain...
it's a car park system, which, when the driver goes in, there's a screen showing where got empty parking space. and that particular empty space will have a light on. All will be running in simulation only...
which means i'll build a model car park with sensors using PIC to take signals and send into the computer, and show it on the screen.
ok... my idea of the electronic part is..
i think i'll just use the basic logic electronics, which is 'high' and 'low'.
every parking lot will be install with LDR and when a car is parked there, there'll be a different signal go into the PIC,(other than those empty). means that, if empty = 'high', then occupied= 'low'.
then, the PIC will send this signal to the computer telling which parking lot is empty.
the PIC will also send a signal to the lights of empty park space.
the problem is, i dunno how to connect the PIC to the computer...
and in the computer, i dunno what kind of software language i have to use.
it's kinda complicated for me.. as my electronics basic is not that good...
pls advice....
i'll keep on updating if there's more idea caming into my mind..
thank guys...
i'm in a rush for this project.. and i've no idea how to start with it
i have to finish it within 1 and half months from now.
ok.. let me explain...
it's a car park system, which, when the driver goes in, there's a screen showing where got empty parking space. and that particular empty space will have a light on. All will be running in simulation only...
which means i'll build a model car park with sensors using PIC to take signals and send into the computer, and show it on the screen.
ok... my idea of the electronic part is..
i think i'll just use the basic logic electronics, which is 'high' and 'low'.
every parking lot will be install with LDR and when a car is parked there, there'll be a different signal go into the PIC,(other than those empty). means that, if empty = 'high', then occupied= 'low'.
then, the PIC will send this signal to the computer telling which parking lot is empty.
the PIC will also send a signal to the lights of empty park space.
the problem is, i dunno how to connect the PIC to the computer...
and in the computer, i dunno what kind of software language i have to use.
it's kinda complicated for me.. as my electronics basic is not that good...
pls advice....
i'll keep on updating if there's more idea caming into my mind..
thank guys...