• Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Can't find connector small enough

Status
Not open for further replies.

Flyback

Well-Known Member
Hello,
Hello, we need a wire to board connector, 2 way. Size less than 13mm x 8mm (length x width), and height less than 10mm
We need the connector (>0.5A) and rated to 400V at least. Though in nominal use it will have 75V between terminals.
This is the connector (Wago) we currently use and its too big......
Wago 2060-402/998-404 connector:

http://www.farnell.com/datasheets/2...MIuJKv2sXw1wIVRrcbCh19bQMeEAAYASAAEgKaW_D_BwE

We simply cannot find anything, we have searched Wago, Pheonix, Molex, JST, etc, but nothing.
Any ideas appreciated?
 

alec_t

Well-Known Member
Most Helpful Member
Does it have to be push-button type? Screw type would widen the field of search.
 

dknguyen

Well-Known Member
Most Helpful Member
Are you just allowed to use a 3 position 0.100" headers and crimp housings (with or without a latch) where the center position is not populated?

The voltage rating says 250VACrms /176VDC but below it says 500V insulation resistance between adjacent pins. I'm not entirely sure what the difference is between the two ratings.
http://www.molex.com/pdm_docs/ps/PS-7879-001.pdf
 
Last edited:

Externet

Active Member
Last edited:
Status
Not open for further replies.

Latest threads

EE World Online Articles

Loading
Top