CAN protocol using mikroc pro by pic18f2580

hi every one there , guys i need to verify that can we use pic18f2580 for can protocol using mikrocpro, i knew pic18f448/258/458 can be used using mikrocpro, but im not 100% sure about pic18f2580 , i think it must work as it is advanced version and can entertain all modes.

It will work just set the chip up right the fuses and configures and it will work if you no how to use it.

thanx dear , guys i want to ask one thing more which is about termination of canbus , i gone through some notes which describes to terminate the can bus using 120 ohm resistor i dont manage this value resistor can u tell me how can we setup this.

you use 120 Ohm resistor on both ends of the two wire bus