CAN protocol using mikroc pro by pic18f2580

[einton]

hi every one there , guys i need to verify that can we use pic18f2580 for can protocol using mikrocpro, i knew pic18f448/258/458 can be used using mikrocpro, but im not 100% sure about pic18f2580 , i think it must work as it is advanced version and can entertain all modes.

 

[be80be]

It will work just set the chip up right the fuses and configures and it will work if you no how to use it.

 

[einton]

thanx dear , guys i want to ask one thing more which is about termination of canbus , i gone through some notes which describes to terminate the can bus using 120 ohm resistor i dont manage this value resistor can u tell me how can we setup this.

 

[be80be]

you use 120 Ohm resistor on both ends of the two wire bus