G glmclell New Member Aug 1, 2004 #1 hi gang. is there a way to 'force' eagle 4.11r2 to do a single layer layout? i have a board with only 2 ic's and an transistor, but eagle insists on making it a 2 layer board, which i can't etch at home! i went into the drc setup and set layer setup to 1, but it looks like it's still doing 2 layers, as there are red and blue traces on the screen any thoughts are appericated!
hi gang. is there a way to 'force' eagle 4.11r2 to do a single layer layout? i have a board with only 2 ic's and an transistor, but eagle insists on making it a 2 layer board, which i can't etch at home! i went into the drc setup and set layer setup to 1, but it looks like it's still doing 2 layers, as there are red and blue traces on the screen any thoughts are appericated!
Phasor Member Aug 2, 2004 #2 In the Autorouter setup, under the "General" tab, set the preferred direction of the top layer (layer 1) to "N/A". That should do the trick 8)
In the Autorouter setup, under the "General" tab, set the preferred direction of the top layer (layer 1) to "N/A". That should do the trick 8)