hi gang.
is there a way to 'force' eagle 4.11r2 to do a single layer layout?
i have a board with only 2 ic's and an transistor, but eagle insists on making it a 2 layer board, which i can't etch at home!
i went into the drc setup and set layer setup to 1, but it looks like it's still doing 2 layers, as there are red and blue traces on the screen
any thoughts are appericated!
is there a way to 'force' eagle 4.11r2 to do a single layer layout?
i have a board with only 2 ic's and an transistor, but eagle insists on making it a 2 layer board, which i can't etch at home!
i went into the drc setup and set layer setup to 1, but it looks like it's still doing 2 layers, as there are red and blue traces on the screen
any thoughts are appericated!