My electronics is a bit rusty, let me know what you guys think about the circuit below.
Basically, there is a 0-5V input that increases as boost goes up, and decreases as boost goes down.
The point is to open the solenoid when a certain boost setpoint is reached. The setpoint is adjusted via the 5k pot.
Let's say my target boost is 18psi (3.6V), so the pot would be adjust to 3.6V.
Below 3.6V, the solenoid is closed.
Above 3.6V, the solenoid is opened.
The solenoid will actually open/close once it reaches the setpoint to maintain the required boost (feedback)
Think it will work? Any comments/suggestions/upgrades?
Basically, there is a 0-5V input that increases as boost goes up, and decreases as boost goes down.
The point is to open the solenoid when a certain boost setpoint is reached. The setpoint is adjusted via the 5k pot.
Let's say my target boost is 18psi (3.6V), so the pot would be adjust to 3.6V.
Below 3.6V, the solenoid is closed.
Above 3.6V, the solenoid is opened.
The solenoid will actually open/close once it reaches the setpoint to maintain the required boost (feedback)
Think it will work? Any comments/suggestions/upgrades?