I have connected the BlueDongle to the PC and am using Hyperterminal to communicate with it. Upon sending "AT" to the device it returns OK
So I am assuming that it works fine.
I am interfacing the BlueSMiRF with a PIC (16F873) and am using printf
in PICC to send data to the device (Pin C6 on PIC to Rx on the BlueSMiRF). This is where the trouble starts.
I do not get any transmission (ie I see nothing on the Hyperterminal screen); I dont even know if I am getting anything sent.
Can someone please help me to get started on solving this problem?