Newbie needs help

[Rhubschmitt]

Hello everyone

I am trying to fix a charger for the powered floor jack. I took it apart and found it must have falling and when it hit the ground 2 capacitors broke off the board. I am trying to find replacement ones and I'm having some difficulty can anyone help me out
The capacitor has the following information on it
Ru chang
2200uf200v
25/105/21
It is
1 and 3/8 wide
2 and 3/8 long with the pins
Any help would be greatly appreciated
Thank you
Rhubschmitt@gmail.com

 

[Doug]

Look on digikey.com and mouser.com
2200uf. 200v or a little higher
105 degree and choose a size

 

[danadak]

This will get you started, and you can filter further to get to needed cap.

Capacitors | Aluminum Electrolytic Capacitors | DigiKey Electronics

Aluminum Electrolytic Capacitors are in stock at DigiKey. Order Now! Capacitors ship same day

www.digikey.com

Regards, Dana.

 

[Matthewjtaylor]

Hello everyone

I am trying to fix a charger for the powered floor jack. I took it apart and found it must have falling and when it hit the ground 2 capacitors broke off the board. I am trying to find replacement ones and I'm having some difficulty can anyone help me out
The capacitor has the following information on it
Ru chang
2200uf200v
25/105/21
It is
1 and 3/8 wide
2 and 3/8 long with the pins
Any help would be greatly appreciated
Thank you
Rhubschmitt@gmail.com

As Doug mentioned, Digikey and Mouser are best resources for finding capacitors. Just make sure the replacement matches the 2200uF, 200V rating, and the temperature tolerance (105°C). The physical size should be close to the origina.

 

[danadak]

If you go here you can use filter the table for the specs and look
at datasheets to see if results of filter, what parts are being offered
for your filter choices, will fit.

https://www.digikey.com/en/products/filter/aluminum-electrolytic-capacitors/58