polashd
Member
I'm trying to control a bldc motor(1800KV) using MCU (Atmega32) PWM signal (duty cycle controled by a Pot(VR).
I connected it with an ESC(non-branded) and Lipo battery(2s, Mystery 2800mAh).
when i connect it with battery the motor beeps and jurk a little with each beep. But dont start spin.
Beep sequence:
- 1 musical beep.
- 2 beeps
- 1 beep in every second (until i disconnect power)
can anyone please help me.
note: I'm not using any remote control
I connected it with an ESC(non-branded) and Lipo battery(2s, Mystery 2800mAh).
when i connect it with battery the motor beeps and jurk a little with each beep. But dont start spin.
Beep sequence:
- 1 musical beep.
- 2 beeps
- 1 beep in every second (until i disconnect power)
can anyone please help me.
note: I'm not using any remote control