hi, i am looking to make an amp head for a 16 ohms speaker in an amp cab i made. i dont know anything about electronics but when i get decent plans i can easily follow them and put it together (its something i was born with i think ) (plus i have a freind doing electronics at university whos coming back soon and im gonna get him to give me some pointers)
i am looking to make a valve amp with basically just a volume switch, treble and bass. i would also like maybe a tremolo but that might asking a bit much.
anyways, ive had a good search around the internet and found hundreds of plans but there all to complicated for me. what i was looking for was a plan that has the curcuitry set out as if it were just a drawing of what the inside looked like in real life with just some markings on it like, what the valves are and where they connect to, things like that. i have attached a rubbish picture i drew to give an example of what i mean.
this may be asking a lot but if anyone can help i will appreciate it alot
thanks
adam[/img]
i am looking to make a valve amp with basically just a volume switch, treble and bass. i would also like maybe a tremolo but that might asking a bit much.
anyways, ive had a good search around the internet and found hundreds of plans but there all to complicated for me. what i was looking for was a plan that has the curcuitry set out as if it were just a drawing of what the inside looked like in real life with just some markings on it like, what the valves are and where they connect to, things like that. i have attached a rubbish picture i drew to give an example of what i mean.
this may be asking a lot but if anyone can help i will appreciate it alot
thanks
adam[/img]