Hi,
Excuse my ignorance, but I attatched 1.jpg showing the schematic and a
capture of the AT90S1200 pinouts from the (data sheet pdf) along side of the schematic.
The capture from the pdf does not label ,show or mention CLK , just reset ,vcc, mosi miso, ect as you can clearly see.
And as my pcb drawing shows, I am fine with these connections, but not CLK.
Perhaps my question should have been, (NOT WHERE DO I CONNECT ON THE IC)
but rather ,as the pdf does not show CLK then what pin on the ic is known to be CLK ,as used by the experienced people out there.
Regards.