hello guys,
i am currently doing a simple simulation about Low Frequency Wien Bridge Sinewave Oscillators and i want to display the signal output which is sine wave output..but i don't know how to setting up the analogue display in proteus..i have done so many ways and search in the internet so many times but it is not displayed..the circuit is working fine since i get the desired output value but only the signal is i cannot display..for anyone whose are expert and more familiar,pls i ned to share your knowldge to...
Thank you very much...
i am currently doing a simple simulation about Low Frequency Wien Bridge Sinewave Oscillators and i want to display the signal output which is sine wave output..but i don't know how to setting up the analogue display in proteus..i have done so many ways and search in the internet so many times but it is not displayed..the circuit is working fine since i get the desired output value but only the signal is i cannot display..for anyone whose are expert and more familiar,pls i ned to share your knowldge to...
Thank you very much...