StudentSA
Member
Good Day
I have an analog voltage ranging from 0V - 5V I would like to display a value between 0 and 9999 depending on the voltage level i.e. 0V = 0 on display and 5V = 9999 on display.
What is the best way to achive this WITHOUT the use of a microcontroller?
I was thinking of implementing a Voltage to Frequency (V-F) convertor followed into a counter that is configured for a specific reset/latch period?
Any further suggestions will be appreciated.
Regards,
StudentSA
I have an analog voltage ranging from 0V - 5V I would like to display a value between 0 and 9999 depending on the voltage level i.e. 0V = 0 on display and 5V = 9999 on display.
What is the best way to achive this WITHOUT the use of a microcontroller?
I was thinking of implementing a Voltage to Frequency (V-F) convertor followed into a counter that is configured for a specific reset/latch period?
Any further suggestions will be appreciated.
Regards,
StudentSA