amol.gulhane07
Member
We are using atmega 128 for automotive chassis robot.We have written proper program for its movement.But we are facing problem with atmega controller.We have used ADC (PORTF)of atmega128 for reading the values of joysticks.
The prob is:
Once we Burn The program in the atmega128,Robot performs desired function properly for few trials.But after few trials THE ADC PORT is not working properly...
If we PULL-UP it through prog,it gives us ADC VALUES between 0-40(initially it showed full range(0-255))
WE tried it on different Atmega's But got no solution to this....
Please see to it....
The prob is:
Once we Burn The program in the atmega128,Robot performs desired function properly for few trials.But after few trials THE ADC PORT is not working properly...
If we PULL-UP it through prog,it gives us ADC VALUES between 0-40(initially it showed full range(0-255))
WE tried it on different Atmega's But got no solution to this....
Please see to it....