Mike0rr
New Member
I'm working on a little project calculator and I'm right at the tail end but I'm stuck on this one last issue. I have an 8bit number coming out of my circuit that I need fed to a few 7 segment displays; (Example: Decimal 52, is Binary 00110100). I would assume I need to break this down to BCD but I can not seem to find a way to do so and I don't want to assume that is the correct way to go about this since I can't find much information on the subject. This is all being done on IC's.
Long story short; How would I go about taking my 8bit number and displaying it on one-three 7Seg Displays? Only using IC's, (no micro controller). It doesn't really matter how large the circuit is as I fully understand it may take quite a few chips and possibly need more than one conversion here.
Long story short; How would I go about taking my 8bit number and displaying it on one-three 7Seg Displays? Only using IC's, (no micro controller). It doesn't really matter how large the circuit is as I fully understand it may take quite a few chips and possibly need more than one conversion here.