4 port Wilkinson combiner / splitter question

Status
Not open for further replies.
I am sad to say my maths are far below the required to work out inductance and capacitance values for a 4 port Wilkinson combiner based on this YouTube video linked below. I successfully made a 3 port one using this on line calculator (below), but despite intense Googling I cannot find one for a 4 port version. I need to make one for four 50 Ohm port impedances in and out on 137.5 kHz (LF). A big ask but if someone has bit of spare time the figures for the needed caps and inductances would be GREATLY appreciated, some Paypal money is not a problem! I will be using a star format resistor network, and I know these need to be Zo (50 Ohms) each.


This is the video on multi port Wilkinsons:
This is the on line 3 port calculator: https://leleivre.com/rf_wilkinson.html

Thanks for any help!
 
OK, try this:

For Zo = 50 Ohm
F = 137.5 kHz
Ports = 4

L = 115.8uH
C = 11.575nF (4C = 46.3nF)

JimB
 
Thank you VERY much JimB that was very helpful and using an on line reactance calculator I managed to get the same result and now understand the procedure enough to build it
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…