Hi All
I am trying to genereate a low frequency- 15Hz staircase square wave using a PIC18f8722 development board along with a DAC (AD7840) which can be used in either parallel or serial input mode.
I am right now considering to implement it by changing the parllel input bits values at output port after a time delay 33ms.
Do you think this is a good way of doing it. Please suggest a method if this sounds crude.
Thanks
I am trying to genereate a low frequency- 15Hz staircase square wave using a PIC18f8722 development board along with a DAC (AD7840) which can be used in either parallel or serial input mode.
I am right now considering to implement it by changing the parllel input bits values at output port after a time delay 33ms.
Do you think this is a good way of doing it. Please suggest a method if this sounds crude.
Thanks