I have a transformer that I got from MPJA: https://www.mpja.com/prodinfo.asp?number=7846+TR It is a 120v to 24v center tap. I want to use each 12v on the low side seperately
It came with zero wiring diagrams. Can you help me figure out what goes where
On the high side I have 2 red, 2 blk. What are they? I assume one gets the hot lead and one gets a neutral? Or does one get a ground?
On the low side I have 2 blue and 1 yellow. I asume the 2 blue are 12 v. What is the yellow? Ground?
Also when the power leaves the low side the first thing it will hit is a 25A 50v bridge rectifier. It has no diagram either. Just a notch cut off of one of the corners. I would assume this to be the 50vdc positive output side and the side oppositely diagonal to be the negative. The other 2 terminals would be AC input? Do both of those terminals have to be used?
Please forgive me if these are newb questions. This is my first project.
It came with zero wiring diagrams. Can you help me figure out what goes where
On the high side I have 2 red, 2 blk. What are they? I assume one gets the hot lead and one gets a neutral? Or does one get a ground?
On the low side I have 2 blue and 1 yellow. I asume the 2 blue are 12 v. What is the yellow? Ground?
Also when the power leaves the low side the first thing it will hit is a 25A 50v bridge rectifier. It has no diagram either. Just a notch cut off of one of the corners. I would assume this to be the 50vdc positive output side and the side oppositely diagonal to be the negative. The other 2 terminals would be AC input? Do both of those terminals have to be used?
Please forgive me if these are newb questions. This is my first project.