Anyone have any theory's on how to drive one stepper motor but off two driver circuits.
To clarify things a bit. I have copier that drives a stepper motor. I need to drive the same motor from another circuit. I was going to t into the logic of the board but this is not possible and the motor is driven directly from a control board.
The motor voltage is 24v. I can drive the motor via a pic and stepper motor driver but if i connect both at the same time I would expect smoke as a result.
thanks,
jason
To clarify things a bit. I have copier that drives a stepper motor. I need to drive the same motor from another circuit. I was going to t into the logic of the board but this is not possible and the motor is driven directly from a control board.
The motor voltage is 24v. I can drive the motor via a pic and stepper motor driver but if i connect both at the same time I would expect smoke as a result.
thanks,
jason