Long Story short... my Makita 6500 heat gun that's had bugger all use was loaned to a mate who used it to melt a candle. Don't even ask. I've been told he held the nozzle of the heat gun into an upside down glass container to melt the candle, and then after letting the wax partly cool he started...
Hi forum.
This is just a resyme of experience about the use of heat gun to remove (all) components from PCB board as opposed to use soldering iron.
Summer is finally knocing on the door, most of last winter snow is gone.
So during the winter months I have collected some PCB boards from defect...