Hello,
My question is related to CADENCE software simulation.
I am doing a process corner simulation of a simple inverter using ADXL in CADENCE. But the problems are:
1_ When I run only the nominal corner it simulates successfully as shown in the figure.
2-But when I add worse power /worse...
hi i'm testing the layout for my circuit using cadence calibre tool that is a transimpedance amplifier and im using cadence 6.14. drc test is ok but i encountered some errors in lvs check . there is 16 errors including 1 port error which points to gnd and i couldn't fix it and i checked the...