Ok, so I'm pretty new at this, last time I etched a board was in highschool and I can't remember much. But this is what I need and I hope someone can help me. I'm pretty sure I can build the board given the layout and what I should do.
I want to create a board that has 6 different pressure sensitive switches that when pressed (one at a time,) will display either a letter or a number on an alpha-numeric 1 or 2 digit display. The switches need to display the numbers 1 through 5 and the last switch if pressed, displays the letter R. Also, if no switch is pressed, the LCD displays the letter N. It needs to be 12 volt also.
If someone thinks they can help me email me please.
Thanks![/b]
I want to create a board that has 6 different pressure sensitive switches that when pressed (one at a time,) will display either a letter or a number on an alpha-numeric 1 or 2 digit display. The switches need to display the numbers 1 through 5 and the last switch if pressed, displays the letter R. Also, if no switch is pressed, the LCD displays the letter N. It needs to be 12 volt also.
If someone thinks they can help me email me please.
Thanks![/b]