Hi,
I have a simple circuit I am trying to get to work.
My CNC machine uses a probe to touch a part with. When the probe touches the part it breaks continuity and this is seen by the machine. When that happens the machine marks the x/y or z location.
The circuit is fairly simple I am just concerned about wiring it wrong and frying a board.
I have attached a pdf that has all the info one should need to figure out how to wire this.
I need it layed out in idiot format. So I can clearly understand.
Thanks,
Eric
I have a simple circuit I am trying to get to work.
My CNC machine uses a probe to touch a part with. When the probe touches the part it breaks continuity and this is seen by the machine. When that happens the machine marks the x/y or z location.
The circuit is fairly simple I am just concerned about wiring it wrong and frying a board.
I have attached a pdf that has all the info one should need to figure out how to wire this.
I need it layed out in idiot format. So I can clearly understand.
Thanks,
Eric