Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
It is not hard to make toner transfer PCBs if you use PulsarProFx. Harder if you do not.
Nigel, This is a little late but I was out of town.... Thanks for posting that code in assembler. It's been an interesting study. A lot more complex than I thought it would be, but I guess that's what happens when you know how to do it right. Do you have a listing somewhere that shows what all your commands mean? There are some assembler commands that you use that I'm not familiar with and can't figure out.
Sorry not the assembler commands but things like var8+1 I see that var8 is defined but I didn't see var8+1...... Is it just like my logic is telling me, and it puts it in the next folder?
I'm still reading up on what I'm going to need for my prohject. Now I'm starting to think I want to use a chip with a premade H-Bridge instead of building it, I'm very result oriented. I have an L298N, would that work right with a PWM input to adjust the speed of the motor? It seems like it should but I don't want to assume when I'm not very knowledgeable about these chips.
well for now we are talking about very small motors, the kind you would find in toys, like lego motors. Infact I plan to build one with lego connections that can drive two motors at variable speed in both directions by remote, for tank syle drive RCs, I figure its a good starter project for RC robots because its small and the legos provide most of the structure.