NewGeek
New Member
When I try to compile my code I get a bunch of errors, but that's not the problem. Using MPLAB IDE 6.6
The problem is my code is only 105 lines long. The error messages say that I have errors on lines 137, 145, 160 etc. This makes debugging rather difficult as these lines dont exist.
Here is another possible clue: On some of these non-existant lines, the error is #116: "Address label duplicated or different in second pass"
This makes me think it is looping and adding line numbers somehow?
Can anyone explain this?
BTW, this code is the 1-wire protocol for Dallas DS1820 temp sensor downloaded from the Dallas website.
The problem is my code is only 105 lines long. The error messages say that I have errors on lines 137, 145, 160 etc. This makes debugging rather difficult as these lines dont exist.
Here is another possible clue: On some of these non-existant lines, the error is #116: "Address label duplicated or different in second pass"
This makes me think it is looping and adding line numbers somehow?
Can anyone explain this?
BTW, this code is the 1-wire protocol for Dallas DS1820 temp sensor downloaded from the Dallas website.