Hi all,
I have designed the buck switching power supply design from TI web bench which gives 5V , 6amp When i Tested this circuity over PCB board it gives 5v but it does not give current more than 1 amps.
I Tested the same circuitry on general purpose board setup and i got 5v , 6 amps of current.
Can anyone say whats wrongs in my PCB board?? Is that a PCB track problem?
1.components values and design used in both the case are same.
I have designed the buck switching power supply design from TI web bench which gives 5V , 6amp When i Tested this circuity over PCB board it gives 5v but it does not give current more than 1 amps.
I Tested the same circuitry on general purpose board setup and i got 5v , 6 amps of current.
Can anyone say whats wrongs in my PCB board?? Is that a PCB track problem?
1.components values and design used in both the case are same.