Hello again folks! I have come across a neat design on-line that I am trying to make an etch-able circuit board from , and I have a question about it! It is rated for 24 volts.
I am wanting to drop the voltage to about 5 volts to bias two electret mics while keeping it at the right voltage of 24 volts at the chip.
Is there a way to do this with resistors or should I feed my mics from a separate circuit and plug them into the inputs of the amplifier? The site and design is at https://schematics.circuitdiagram.net/viewer.php?id=jdv1335145437w.gif
Thank you very much in advance for your help in this!
I am wanting to drop the voltage to about 5 volts to bias two electret mics while keeping it at the right voltage of 24 volts at the chip.
Is there a way to do this with resistors or should I feed my mics from a separate circuit and plug them into the inputs of the amplifier? The site and design is at https://schematics.circuitdiagram.net/viewer.php?id=jdv1335145437w.gif
Thank you very much in advance for your help in this!