I'm working on simulating a power supply in multisim. Currently all I have is the 120V source ran through a transformer, through a bridge diode, through a filter capacitor, and to the load (just a resistor). It works fine, until I add the capacitor. When I add the capacitor I get 0V on my oscilloscope readings, instead of a filtered FW signal. I have had this problem countless times and wanted to see if it was me or multisim. The file is included. Notice the GND of the oscope is connected to the circuit, the image just cut it off.
Thanks
Notice, change .txt to .ms8
Thanks
Notice, change .txt to .ms8