Hi folks new to the forum with my first post here. I've got a mitre saw with a faulty laser. I've replaced the laser and know thats working. Having traced the circuit board out (i think) I came to a burnt out resistor. I'm pretty sure this is the problem. I have tried to read it but not sure I'm doing it right. I've come up with 1000000 ohm with -/+2% tolerance. Underneath it written on the circuit board it says 25R / 1W. Can someone tell me what resistor I need (i.e. what i need to type into ebay) cheers for any help you can give.
I've attached a pic. if you cant see it to well, its a light blue cover with a brown band (burnt section) black band green band red band.
I've attached a pic. if you cant see it to well, its a light blue cover with a brown band (burnt section) black band green band red band.