I need a stepper motor driver!

[tj107us]

Does any one have or can get a schematic drawing for a stepper motor driver? The stepper motor im going to use in a Sanyo Cp-043 14.5 volts. If i could get a schematic drawing that will make it go forword and backword and make it able to position itself using a computer. The stepper motor has six wires.

thanks in advance,
Jacob

 

[moody07747]

only stepper motor controller i know of uses 4 wires and its here

https://www.aaroncake.net/circuits/stepper.htm

dont know if you could change that around

 

[Nigel Goodwin]

only stepper motor controller i know of uses 4 wires and its here

https://www.aaroncake.net/circuits/stepper.htm

dont know if you could change that around

The diagram in the link has SIX wires, two are the power inputs, and four are the connections to the driver - it's a standard unipolar circuit.

If you google for "stepper motor tutorial" you will find plenty of information on steppers and how to run them.

 

[fsahmed]

Try searching for UCN 5804

 

[tj107us]

what is a UCN 5804?

 

[fsahmed]

UCN 5804 is a stepper motor driver IC, takes TTL level input, can run steppers upto 30 volts, 1.25A continuous current

 

[tj107us]

what does it look like and how can i get it?

 

[Nigel Goodwin]

what does it look like and how can i get it?

If you had you location filled in perhaps we could make suggestions where you could get them?.

 

[tj107us]

its there now