Design Help with Out of Spec Stepper Motor

[tebiekoud23]

Hello,

Good day.

I'm doing a custom PCB for a stepper motor and I´ll be using a drv8825. I have followed the typical application of the IC but the motor I have doesn´t match the design requirements. I´m new to electronics, and don´t understand much yet, saying this, what I´ll need to change to match the following motor?

https://www.oyostepper.it/goods-126...-42x42x38mm-Albero-con-taglio-a-D-4-fili.html

Thank you in advance for your support.

Regards,

CSC

 

[Musicmanager]

Have a look at this .. .. . https://www.makerguides.com/drv8825-stepper-motor-driver-arduino-tutorial/

MM

 

[rjenkinsgb]

The motor is fine. All you need to do is set the current limit on the DRV8825 to no more than the motor rated current; the driver IC takes care of everything else & it will be fine on 12V or 24V.

The higher the voltage, the faster the motor can run and maintain a reasonable torque level.

 

[tebiekoud23]

OK, thanks for your suggestion.