sticks_678
New Member
Hi,
I would like to make a simulation with 3 voltage controlled switches with Ltspice. Below, the circuit :
But, there is a problem. If I put 1V or 0V, like in the picture, in input of the switch there is something in both output. I don't understand why.
Any ideas ?
Thank you in advance.
I would like to make a simulation with 3 voltage controlled switches with Ltspice. Below, the circuit :
But, there is a problem. If I put 1V or 0V, like in the picture, in input of the switch there is something in both output. I don't understand why.
Any ideas ?
Thank you in advance.