Hello, I am trying to power an Arduino using this Fixed output regulator, where the power input is 19.5v 700ma from a wall wart. I want to send 7v to the arduino, and before the regulator circuit, I need the input power to also momentarily trigger a 12 volt solenoid. (12 to 20v) How do I configure this BA07CC0T? I can figure out the solenoid power input. I am new to this, and only do a few project in a decade, I do not understand ohms law or math equations to figure out electronics. I have tried to google help, but can not find the answer.
Thank you for any help.
Steve
Here is the data sheet if needed: https://www.electro-tech-online.com/custompdfs/2013/06/baxxcc0t_series-e-210264.pdf
Thank you for any help.
Steve
Here is the data sheet if needed: https://www.electro-tech-online.com/custompdfs/2013/06/baxxcc0t_series-e-210264.pdf