nickelflippr
Member
Anyone messing with Design Spark pcb files? Just getting started with them to get beyond the Diptrace demo limitations. I want to get a board done with no solder mask on the bottom layer of a two layer board. The bottom layer will be all gnd plane, no vias or tracks.
So is there a tick someplace where you can present an empty file, or just offering up an empty file in name only? May have to try a sites drc, to see if they will accept gerbers without the bottom solder mask layer?
So is there a tick someplace where you can present an empty file, or just offering up an empty file in name only? May have to try a sites drc, to see if they will accept gerbers without the bottom solder mask layer?