YOoooooooooooooooooooooooo
Hello, simple circuit
I have a strip of LEDS i want to connect to the inside of my boot. i know where the wire is for the boot lamp so it only turns on when the boot is open but.
If i connect LEDS to 12V car battery they will just explode everyware right. what do i do so that they will always work?
-Also, will it matter the way i connect the LED'S?? Series or parallel which is best??????
and will this circuit depend on the amount, i think it will. If i have some in my boot, some under the dash board, some here, some there. and they have 12 LED's on them, or 6, or 8 etc how will the circuit change, and how can i know this so everytime i connect LEDS of a certain amount, i will make it work.
Separate but related matter
- Having LED's in the boot flash to music at the flick of a switch..
--> Same LED's in boot that are controlled off the boot switch, i want to be connected to a music to LED sync circuit that i can flick a switch and they will go.
Hope you know how to help brah
Hello, simple circuit
I have a strip of LEDS i want to connect to the inside of my boot. i know where the wire is for the boot lamp so it only turns on when the boot is open but.
If i connect LEDS to 12V car battery they will just explode everyware right. what do i do so that they will always work?
-Also, will it matter the way i connect the LED'S?? Series or parallel which is best??????
and will this circuit depend on the amount, i think it will. If i have some in my boot, some under the dash board, some here, some there. and they have 12 LED's on them, or 6, or 8 etc how will the circuit change, and how can i know this so everytime i connect LEDS of a certain amount, i will make it work.
Separate but related matter
- Having LED's in the boot flash to music at the flick of a switch..
--> Same LED's in boot that are controlled off the boot switch, i want to be connected to a music to LED sync circuit that i can flick a switch and they will go.
Hope you know how to help brah
Last edited: