I am going to send my PCB layout to www.olimex.com who are going to make my PCB.
They recuire som standard drillsizes. Look here: https://www.olimex.com/pcb/index.html
When i use the standard symbols in Eagle 1.44 like e.g DIL8 the drillholes doesn't match olimex drillsizes: (0.7 0.9 1.0 1.1 1.3 1.5 2.1 3.3)mm
How do i change them? Is there any place where i can change the standard, so i don't have to modify all symbols?
They recuire som standard drillsizes. Look here: https://www.olimex.com/pcb/index.html
When i use the standard symbols in Eagle 1.44 like e.g DIL8 the drillholes doesn't match olimex drillsizes: (0.7 0.9 1.0 1.1 1.3 1.5 2.1 3.3)mm
How do i change them? Is there any place where i can change the standard, so i don't have to modify all symbols?