very unskilled in electronics but a fast learner. I have a PM AC motor that in free spin registers 5-150 volts in 3 phase. I've switched to DC with a 3 phase rectifier but under a load such as checking amp draw the voltage reduces dramatically as the motor slows down.
Looking for a solution to realize about 50 volts DC with 10-15 amps consistently. I have to mention that the drive for this motor is going to be wind at anywhere from 30-70 mph average so the input voltage will vary. Is this possible? Any suggestions?
Looking for a solution to realize about 50 volts DC with 10-15 amps consistently. I have to mention that the drive for this motor is going to be wind at anywhere from 30-70 mph average so the input voltage will vary. Is this possible? Any suggestions?