aljamri
Member
Hi,
for a simple project, I'm using PortA as switch ( following NG switch Tutorial 2.2 ), everything is working o.k., except for A6 is giving 2.4v where as all the other switches pins are getting 5V before the switches pressed. The micro controller interpret it as the key is pressed.
the same pen can be used as OSC2 and CLKOUT, but I'm not using any of theses features. is there any thing to be checked in the initial setup.?
for a simple project, I'm using PortA as switch ( following NG switch Tutorial 2.2 ), everything is working o.k., except for A6 is giving 2.4v where as all the other switches pins are getting 5V before the switches pressed. The micro controller interpret it as the key is pressed.
the same pen can be used as OSC2 and CLKOUT, but I'm not using any of theses features. is there any thing to be checked in the initial setup.?