My daughter got a Zhu hamster for christmas. Problem is it doesn't work properly inside the hamster ball. Every time it starts the tilt sensor trips out the motor.
There is a design fault as this probleb is all over the net (or at least as all over as it can get ).
Would some one be able to tell me which component is the tilt sensor from this pic?
It's only a tenner so if I can just bypass (solder in a link or something) then it will keep my daughter happy..
That goes down to 2 micro switches at the front, there is no markings at all on it. Don't think it is what I'm looking for though. Have checked it with an ohm meter and it doesn't seem to change either way up.