Nah, the next step is to see if i can make it blink on my own...
It would be nice if i had a tutorial, though...
(free...)
blueroomelectronics said:
What was MPLAB complaining about?
Most of it was my fault...
First i had my ICD2 plugged into Com2, instead of Com1. Then MPLAB found it on it on com2, and decided to use it. I didn't have FIFO disabled on Com2. Once i switched ports, it connected fine, but then i couldn't figure out why it would download the program, but wouldn't run... Then i realized i didn't build all. Next it complained because when i copied out of the PDF, it didn't copy the tabs, so i had to put those in... Then it errored out because the file path was longer than 62 characters (wtf!?)
But after that, it blinked... Then i had to go to work...
Yes, i know i have asked this MANY times before, but can someone point me to a good PIC tutorial. I only have 16f877a's, 16f84a's, and 16f887's...
I would do nigel's tutorials, but i don't have that PIC (and i am too lazy to get more free samples...)