Hi,
Im using the XBEE 1mw:
SparkFun Electronics - XBee 1mW Chip Antenna
Ive been trying to read up on them but I find it quite confusing. I was wondering if anyone had any experience with them might be able to help me out.
Im trying to use the standard UART RX and TX pins on my PIC16F628 to send a signal to another Xbee. What im unable to find out is, is this all that is required. Instead, is there additional code that needs to be included in order to initialise the Xbee, or tell it to start transmitting for example.
There are the help files ive been reading:
Thank you for any help you can give,
James
Im using the XBEE 1mw:
SparkFun Electronics - XBee 1mW Chip Antenna
Ive been trying to read up on them but I find it quite confusing. I was wondering if anyone had any experience with them might be able to help me out.
Im trying to use the standard UART RX and TX pins on my PIC16F628 to send a signal to another Xbee. What im unable to find out is, is this all that is required. Instead, is there additional code that needs to be included in order to initialise the Xbee, or tell it to start transmitting for example.
There are the help files ive been reading:
Code:
Example code (not sure if it works but it may be a starting point)
http://forum.sparkfun.com/viewtopic.php?f=6&t=13565
FAQ and more details on the xbee:
http://www.jsjf.demon.co.uk/xbee/xbee.html
Thank you for any help you can give,
James