I'm building DL4YHF's ( www.qsl.net/dl4yhf/winpicpr.html - seems to not respond atmo ) WinPic programmer (Simple) now. The problem is that on the scema the PINs needed to program PIC are connected to 18 pin PIC. On the site, there is also shown adapter to program 8pin PICs. But where to connect wires if I need to program 40 pin chip (18f452 for example)?
VSS = ground (there's 2 of them, both need to be connected)
VDD = +5V , VDD signal of the programmer (also 2 of these)
RB7/PGD = Programmer Data line
RB6/PGC = Programmer Clock line
~MCLR = Programmer VPP line
I'm building DL4YHF's ( DL4YHF's WinPic - A PIC Programmer for Windows - seems to not respond atmo ) WinPic programmer (Simple) now. The problem is that on the scema the PINs needed to program PIC are connected to 18 pin PIC. On the site, there is also shown adapter to program 8pin PICs. But where to connect wires if I need to program 40 pin chip (18f452 for example)?