What is this part, is it just a normal capacitor

It looks like it's just a mains filter capacitor, directly across the switched mains (I'm presuming the black wires at the upper right, go to a switch?).

Why do you want a replacement?.

Hi,
thankyou for your reply, yes the black wires do go to a switch, I am looking to go the 240v motor route in another turntable that I have, which was a 16v turn table which needed a separate external power supply, but the motor has stopped working. I can get both replacement motors 16v and 240v, but im thinking it will be easier to go the 240v route if I can get replacement capacitors. The one in the picture is old and I've not been able to find the same, so im wondering if I can use capacitors of the same rating from else ware.
What do you think?
Thanks
Martyn Topham

It's a "Class Y" suppression capacitor.

2700pF (2.7nF) is not a common value but a 2n2 or 3n3 etc. would be just as good.

Most electrical suppliers should have them, or they are readily available on ebay etc.

eg.

It's not a 'functional' component, and the turntable will work perfectly well without it - it's just there to filter out some of the possible high frequency noise coming down the mains. However, in the UK the mains is exceptionally good anyway, but even in countries with poor mains you won't tell any difference if it's fitted or not.

Hi,
Thankyou for the replies sofar, they are much appreciated. I think I will try the 240v motor route and use capacitors suggested.
Thanks
Martyn Topham

Martyn t said:

Hi,
Thankyou for the replies sofar, they are much appreciated. I think I will try the 240v motor route and use capacitors suggested.
Thanks
Martyn Topham

Click to expand...

One thought - does the 16V motor have electronic speed control?, a mains motor most likely will be fixed speed (based on the mains frequency).

Hi
The 16v motor I have is a fixed speed type 300rpm and uses a 2 tier pulley small for 33 and large for 45 as far as I'm aware the 240v motor is the same

Martyn t said:

Hi
The 16v motor I have is a fixed speed type 300rpm and uses a 2 tier pulley small for 33 and large for 45 as far as I'm aware the 240v motor is the same

Click to expand...

DC motors often have a screwdriver adjustment hole in the bottom of them, but as long as the speed is set to the same as the AC motor, then you should be OK - it would have been more of a concern if there was an external speed adjustment - or even worse, an electronic speed selector, rather than a mechanical one.