Gaston
Member
i keep getting an error when trying to program the chip saying Program Verify Error at Program Address 0x000. i read a thread on nige'l forum on this subject and what i gathered was that it is a hardware problem. is that correct?i went to hardware options and checked every button with a logic probe all the way to the zif socket. and i checked the 13 volts. could it be a bad pic? i did find some problems and had to correct them. could i have messed up the pic. is there any way to check it? i'm not sure what the message means. is it just a generic message tha means the verify failed. or is it more specific?