I am currently having a problem with programming an embedded PIC 12f683 using the PICKIT2 system. I developed the prototype on the board supplied with the PICKIT2 and it worked fine, however I now need to program the chip on the final circuit board.
I have made an adaptor using the info supplied in Chapter 3 of the user manual. When I plug it into the header it gives a message to 'INSERT DEVICE'.
Do I need to supply a voltage to the circuit board outwith the voltage coming from the PICKIT2 header? The circuit will be running just under 5V so I don't think it should conflict with the USB.
Any help would be appreciated.
I can post the circuit diagram if required.
Stu
I have made an adaptor using the info supplied in Chapter 3 of the user manual. When I plug it into the header it gives a message to 'INSERT DEVICE'.
Do I need to supply a voltage to the circuit board outwith the voltage coming from the PICKIT2 header? The circuit will be running just under 5V so I don't think it should conflict with the USB.
Any help would be appreciated.
I can post the circuit diagram if required.
Stu