Hi All,
I'm using an 8 bit bidirectional voltage translator chip, TX0108E, between a 5v Pic and a 3v3 device.
All is running well, but normally when you have unused gates on chips you tie them H or L - but wondered what is the best thing to do with the 2 pairs of unused gates I have on this chip ?
Nothing to give any suggestion in the datasheet, just wondered if leaving then open would cause any problems ?
I'm using an 8 bit bidirectional voltage translator chip, TX0108E, between a 5v Pic and a 3v3 device.
All is running well, but normally when you have unused gates on chips you tie them H or L - but wondered what is the best thing to do with the 2 pairs of unused gates I have on this chip ?
Nothing to give any suggestion in the datasheet, just wondered if leaving then open would cause any problems ?