G galeglory New Member Nov 11, 2009 #1 i have a 6 pin unipolar stepper motor, and i can't figure out whitch pin is a,b,c, and d so i can hook it up 2 a control
i have a 6 pin unipolar stepper motor, and i can't figure out whitch pin is a,b,c, and d so i can hook it up 2 a control
M mneary New Member Nov 11, 2009 #2 DC resistance. Ends of a coil are maximum (a few ohms) and the center is half of that.
G galeglory New Member Nov 13, 2009 #3 got it. now it won't turn when i hook it up to my micro controller the way the schematic says
M mneary New Member Nov 13, 2009 #4 We forgot to give you software. You probably also need a driver chip since most steppers need more current than a micro controller can provide.
We forgot to give you software. You probably also need a driver chip since most steppers need more current than a micro controller can provide.
House0Fwax Member Nov 16, 2009 #6 galeglory said: got it. now it won't turn when i hook it up to my micro controller the way the schematic says Click to expand... What schematic?
galeglory said: got it. now it won't turn when i hook it up to my micro controller the way the schematic says Click to expand... What schematic?